Robot Club

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Procedure ======

Follow the steps below to turn the laser engraver on

  - Turn on the power switch to the outlet strip behind the machine\\ \\ <WRAP box>{{ :laserengraver:procedures:poweron:pwr_strip.png |Power Strip}}</WRAP>
  - Turn on the controller power switch on the side of the machine\\ \\ <WRAP box>{{ :laserengraver:procedures:poweron:controller_pwr.png |Controller Power Button}}</WRAP>
  - Turn on the air pump power switch on the side of the machine\\ \\ <WRAP box>{{ :laserengraver:procedures:poweron:airpump_pwr.png |Air Pump Power Button}}</WRAP>
  - Turn on the water cooler power switch\\ \\ <WRAP round tip>When the water cooler turns on it will beep several times as it initializes. If it beeps later on then it means there is a problem with it.</WRAP> <WRAP box>{{ :laserengraver:procedures:poweron:chiller_pwr.png |Water Cooler Power Switch}}</WRAP>
  - Turn on the laser power switch on the side of the machine\\ \\ <WRAP box>{{ :laserengraver:procedures:poweron:laser_pwr.png |Laser Power Button}}</WRAP>
  - Wait for the laser head to stop moving and the controller to finish initializing

After the laser engraver is powered on you can [[:laserengraver:procedures:rundesign|run your design]] on it.