Differences

This shows you the differences between two versions of the page.

--- laserengraver:procedures:poweron [2022/10/20 19:53] – external edit 127.0.0.1
+++ laserengraver:procedures:poweron [2023/10/08 13:18] (current) – Added images jstruebel
@@ Line 1: / Line 1: @@
+====== Procedure ======
+Follow the steps below to turn the laser engraver on
+  - Turn on the power switch to the outlet strip behind the machine\\ \\ <WRAP box>{{ :laserengraver:procedures:poweron:pwr_strip.png |Power Strip}}</WRAP>
+  - Turn on the controller power switch on the side of the machine\\ \\ <WRAP box>{{ :laserengraver:procedures:poweron:controller_pwr.png |Controller Power Button}}</WRAP>
+  - Turn on the air pump power switch on the side of the machine\\ \\ <WRAP box>{{ :laserengraver:procedures:poweron:airpump_pwr.png |Air Pump Power Button}}</WRAP>
+  - Turn on the water cooler power switch\\ \\ <WRAP round tip>When the water cooler turns on it will beep several times as it initializes. If it beeps later on then it means there is a problem with it.</WRAP> <WRAP box>{{ :laserengraver:procedures:poweron:chiller_pwr.png |Water Cooler Power Switch}}</WRAP>
+  - Turn on the laser power switch on the side of the machine\\ \\ <WRAP box>{{ :laserengraver:procedures:poweron:laser_pwr.png |Laser Power Button}}</WRAP>
+  - Wait for the laser head to stop moving and the controller to finish initializing
+After the laser engraver is powered on you can [[:laserengraver:procedures:rundesign|run your design]] on it.