3dprinter:procedures:levelbed
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 3dprinter:procedures:levelbed [2022/10/14 12:35] – jstruebel | 3dprinter:procedures:levelbed [2022/10/20 19:53] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Procedure ====== | ||
| + | Follow the steps below to get the bed level and the right position from the nozzle | ||
| + | |||
| + | - Home the machine | ||
| + | - Push the knob on the front of the display | ||
| + | - Turn the knob to the right to scroll down to the Motion entry and push the knob | ||
| + | - Turn the knob to the right to scroll down to the Auto Home entry and push the knob | ||
| + | - Wait for the machine to stop moving | ||
| + | - Disable the stepper motors | ||
| + | - Push the knob on the front of the display | ||
| + | - Turn the knob to the right to scroll down to the Motion entry and push the knob | ||
| + | - Turn the knob to the right to scroll down to the Disable Steppers entry and push the knob | ||
| + | - Turn the knob to the left to scroll up to Main entry and push the knob | ||
| + | - Turn the knob to the left to scroll up to the Info Screen entry and push the knob | ||
| + | - Move the nozzle with your hand to be over one of the screws on the bottom of the bed | ||
| + | - Slide a piece of paper or the triangle calibrator under the nozzle and turn the screw until there is resistance when sliding the paper | ||
| + | - Repeat the above two steps for the other three screws | ||
| + | - Repeat the above three steps until you don't have to adjust the screws each time | ||
| + | - Print a first layer test design | ||
| + | - Download the STL file from Thingiverse [[https:// | ||
| + | - [[3dprinter: | ||
| + | - [[3dprinter: | ||
| + | - Watch as the 3D printer is running and adjust the leveling screws to get the first layer just right | ||
| + | - Stop the print after the first layer | ||
| + | - Push the knob on the display | ||
| + | - Turn the knob to the right to scroll down to the Stop Print entry and push the knob | ||
| + | - Turn the knob to the right to select Stop and push the knob | ||
| + | - Repeat running the design until the first layer is just right | ||