Differences

This shows you the differences between two versions of the page.

--- laserengraver:start [2023/10/09 19:26] – jstruebel
+++ laserengraver:start [2023/10/09 19:53] (current) – [Projects] jstruebel
@@ Line 1: / Line 1: @@
+====== Laser Engraver ======
+Laser engravers allow you to create your own designs out of wood, paper, or certain foams and plastics. The laser engraver uses a laser to burn the material with high precision. It can either engrave a design into the material or it can cut out pieces of the material. With some special preparation it can even engrave designs on glass and aluminium.
+The laser engravers have the following specifications
+  * Working area: 400mm x 600mm (15.75in x 23.62in)
+  * Laser Type: CO2
+  * Laser Power: 60W
+  * Controller: Ruida RDC-6442G
+====== Rules ======
+Below are the rules that must be followed for safe operation of the laser engravers
+  - The machine must have someone monitoring it whenever it is operating
+  - A [[:laserengraver:procedures:certification|certified operator]] must be present and overseeing the machine whenever it is operating
+  - The laser power key switch must be turned to the off position whenever the cover is open
+  - Only [[:laserengraver:materials|approved materials]] may be used in the machine
+  - Always [[:laserengraver:procedures:poweroff|turn off]] the laser engraver machines before leaving
+====== Procedures ======
+[[:laserengraver:procedures:createdesign|How to Create a Design]]
+[[:laserengraver:procedures:poweron|How to Turn on the Machine]]
+[[:laserengraver:procedures:rundesign|How to Run the Machine]]
+[[:laserengraver:procedures:poweroff|How to Turn off the Machine]]
+[[:laserengraver:procedures:alignlaser|How to Align the Laser]]
+[[:laserengraver:procedures:cleanlens|How to Clean the Lens]]
+[[:laserengraver:procedures:focusdistance|How to Find the Laser Focus Distance]]
+[[:laserengraver:procedures:certification|How to become a Certified Operator]]
+====== Settings ======
+[[:laserengraver:settings:plywood|Plywood]]
+[[:laserengraver:settings:engravers|Laser Engravers]]
+====== Projects ======
+[[:laserengraver:projects:plaque|Wall Plaque]]
+[[:laserengraver:projects:acryliclight|Acrylic Light Stand]]
+[[:laserengraver:projects:cellphonestand|Cell Phone Stand]]
+[[:laserengraver:projects:ornament|Christmas Ornament]]