https://robot-club.tmwkshp.com/ 2026-05-13T12:25:43+00:00 https://robot-club.tmwkshp.com/ https://robot-club.tmwkshp.com/_media/wiki/dokuwiki.svg text/html 2023-09-29T23:16:59+00:00 Anonymous (anonymous@undisclosed.example.com) https://robot-club.tmwkshp.com/laserengraver/procedures/certification?rev=1696029419&do=diff Certification Process Basic Certification The basic certification will allow you to cut and engrave your own designs with approval and oversight of someone with the advanced certification. Someone who has the basic certification has demonstrated the following: text/html 2023-10-13T20:22:27+00:00 Anonymous (anonymous@undisclosed.example.com) https://robot-club.tmwkshp.com/laserengraver/procedures/createdesign?rev=1697228547&do=diff Procedure * Open the Inkscape program on the computer [Open Inkscape] * Draw a rectangle to match the size of your material [Draw Material Outline] * Draw your design using the tools in Inkscape [Use Tools] * Set the stroke and fill colors for each item you draw based on the following list text/html 2023-10-08T20:38:59+00:00 Anonymous (anonymous@undisclosed.example.com) https://robot-club.tmwkshp.com/laserengraver/procedures/poweroff?rev=1696797539&do=diff Procedure Follow the steps below to turn the laser engraver off * Verify that the key on the laser engraver is in the Off position [Key in Off Position] * Turn off the laser power switch on the side of the machine [Laser Power Button] * Turn off the water cooler power switch text/html 2023-10-08T20:18:48+00:00 Anonymous (anonymous@undisclosed.example.com) https://robot-club.tmwkshp.com/laserengraver/procedures/poweron?rev=1696796328&do=diff Procedure Follow the steps below to turn the laser engraver on * Turn on the power switch to the outlet strip behind the machine [Power Strip] * Turn on the controller power switch on the side of the machine [Controller Power Button] * Turn on the air pump power switch on the side of the machine text/html 2023-10-08T21:37:30+00:00 Anonymous (anonymous@undisclosed.example.com) https://robot-club.tmwkshp.com/laserengraver/procedures/rundesign?rev=1696801050&do=diff Procedure Follow the steps below to run the laser engraver to create your design * If the laser engraver is not already on, turn on the machine * Open the Lightburn app on the computer * Load the correct template file for the size material you are using * If there isn't a template already created then