====== Procedure ======

Follow the steps below to run the 3D printer to create your design

  - Insert the SD Card with your design gcode in the slot on the front of the 3D printer
  - Press the knob on the front of the display
  - Turn the knob to the right to scroll down to the Print from Media entry and press the knob
  - Turn the knob to the right to scroll down to the gcode file entry you want to print and press the knob
  - Turn the knob to the right to select the Print option and press the knob
  - Monitor the machine for any errors or defects while you wait for it to finish your design
    - If something happens and you need to stop the print press the knob on the front of the display
    - Turn the knob to the right to scroll down to the Stop Print entry and press the knob
    - Turn the knob to the right to select the Stop option and press the knob
  - Lower the bed to make it easier to remove your design
    - Press the knob on the front of the display
    - Turn the knob to the right to scroll down to the Motion entry and press the knob
    - Turn the knob to the right to scroll down to the Move Axis entry and press the knob
    - Turn the knob to the right to scroll down to the Move Z entry and press the knob
    - Turn the knob to the right to scroll down to the Move 10mm entry and press the knob
    - Turn the knob to the right to change the value to be either at least +100 or 50 greater than the current value and press the knob
    - Turn the knob to the left to scroll up to Move Axis entry and press the knob
    - Turn the knob to the left to scroll up to the Motion entry and press the knob
    - Turn the knob to the left to scroll up to the Main entry and press the knob
    - Turn the knob to the left to scroll up to the Info Screen entry and press the knob
    - Wait for the bed to stop moving down
  - Remove the magnetic sheet from the bed and flex it to release your design
  - Replace the magnetic sheet on the bed
  - Throw away the extra pieces of plastic that are not part of your design

Once your design has been finished you can either [[:3dprinter:procedures:rundesign|run another design]] or [[:3dprinter:procedures:poweroff|turn off the machine]]