====== Procedure ======

Follow the steps below to get the bed level and the right position from the nozzle

  - Home the machine
    - Push the knob on the front of the display
    - Turn the knob to the right to scroll down to the Motion entry and push the knob
    - Turn the knob to the right to scroll down to the Auto Home entry and push the knob
    - Wait for the machine to stop moving
  - Disable the stepper motors
    - Push the knob on the front of the display
    - Turn the knob to the right to scroll down to the Motion entry and push the knob
    - Turn the knob to the right to scroll down to the Disable Steppers entry and push the knob
    - Turn the knob to the left to scroll up to Main entry and push the knob
    - Turn the knob to the left to scroll up to the Info Screen entry and push the knob
  - Move the nozzle with your hand to be over one of the screws on the bottom of the bed
  - Slide a piece of paper or the triangle calibrator under the nozzle and turn the screw until there is resistance when sliding the paper
  - Repeat the above two steps for the other three screws
  - Repeat the above three steps until you don't have to adjust the screws each time
  - Print a first layer test design
    - Download the STL file from Thingiverse [[https://www.thingiverse.com/thing:3339206|Dr Vax 2 Box Calibration]]
    - [[3dprinter:procedures:slicer|Slice]] the design
    - [[3dprinter:procedures:rundesign|Run the design]]
    - Watch as the 3D printer is running and adjust the leveling screws to get the first layer just right
      - Stop the print after the first layer
        - Push the knob on the display
        - Turn the knob to the right to scroll down to the Stop Print entry and push the knob
        - Turn the knob to the right to select Stop and push the knob
  - Repeat running the design until the first layer is just right